Proper Use; Safety Instructions; Layout And Items Supplied; Assembly - EINHELL BT-LS 810 D Manual De Instrucciones

Anleitung_BT_LS_810_D_SPK7:_
GB
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.

1. Proper use

The wood splitter is designed for splitting wood with
maximum lengths of 520/780/1040 mm and a
maximum diameter of 320 mm.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

2. Safety instructions

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
14
17.06.2010 13:36 Uhr Seite 14
3. Layout and items supplied (Fig. 1-2)
1. Splitter
2. Trunk support
3. Hand guards
4. Control lever
5. Trunk support holder
6. Supporting foot
7. Wheels
8. Switch/plug combination
9. Motor
10. Transport handle
11. Trunk holding plates
12. Star nut for adjusting the splitter height
13. Fastening set for trunk holding plates
14. Oil filler/gauge screw
Open the packaging and take out the equipment
with care.
Remove the packaging material and any
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
Inspect the equipment and accessories for
transport damage.
If possible, please keep the packaging until the
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions
Safety instructions

4. Assembly

4.1. Fitting the control lever and hand guards
(Fig. 3-6)
Remove the securing splint pins (Fig. 3/Item 15),
bolts (Fig. 4/Item 16) and washers (Fig. 4/Item 17)
from the holders. Push the hand guards and control
lever, as shown in Figure 5, from the front into the
mount so that the ends of the control lever (Fig.
5/Item A) project through the recesses provided for it
in the control rod (Fig. 5/Item B) (Fig. 5). Fasten the
hand guards with the bolts which you previously
removed (Fig. 5/Item 16). The washers (Fig. 5/Item
17) provide a point of support and should be placed
between the hand guard and the base plate as shown
in Fig. 5. Then secure the bolts with the securing
splint pins (Fig. 6/Item 15).