List Of Pictograms Used Introduction; Intended Use; Features - Parkside PDSS C3 Instrucciones De Funcionamiento

List of pictograms used/Introduction
List of pictograms used
Please read the operating
instructions!
Wear ear protection.
Wear protective gloves.
PNEUMATIC STARTER
ACCESSORY SET PDSS C3
 Introduction
Congratulations! You have purchased one
of our high-quality products. Before initial
setup, please familiarise yourself with the product.
Please also read the safety instructions carefully.
This product must be set up only by people who
have been trained to do so.
KEEP OUT OF THE REACH OF CHILDREN!

Intended use

 
The pneumatic tyre inflator is designed for inflating
bicycle tyres, balls, airbeds, rubber dinghies,
etc. The pneumatic air blow gun is designed for
cleaning objects and hard-to-reach areas with
compressed air. Use the products only as described
and only for the specific applications as stated.
Keep these instructions in a safe place. Ensure you
hand over all documentation when passing the
product on to anyone else. Any use that differs to
the intended use as stated above is prohibited and
potentially dangerous. Damage or injury caused by
misuse or disregarding the above warning is not
covered by the warranty or any liability on the part
of the manufacturer.
14
EN
292180 Druckluft-Einstiegs-Zubehoer-Set_content_LB8.indb 14
Wear eye protection.
Wear a dust mask.
Dispose of packaging properly.
Do not dispose of the product in
household waste!

Features

 
After unpacking the product, please check that all
of the package contents are present and that the
device is in perfect condition. Do not use the device
if it is defective.
1
Manometer
2
Pneumatic tyre inflator with pressure gauge
3
Vent valve
4
Barbed fitting
5
Hose with straight valve connector
6
Trigger lever
7
Pneumatic air blow gun
8
Extension nozzle
Accessories:
14 15
Attachment for ,
9
Ball needle
10
Universal adapter for valves
11
with internal diameter of approx. 9 mm
12
Universal adapter for valves
with internal diameter of approx. 6 mm
13
Valve adapter e.g. for bicycle tyre valves
14
Universal adapter for valves
with internal diameter of approx. 8 mm
15
Adapter for threaded valves, e.g. for dinghies
16
Adapter for vent valves
16
,
28.11.17 14:16