Safety Instructions For Pneumatic Tools - Parkside PDSS C3 Instrucciones De Funcionamiento

Safety instructions for pneumatic tools

Do not work with the device in
explosion hazard areas where
combustible liquids, gases or dusts
are present. Never work on mate-
rials which are or could potentially
be highly flammable or explosive.
For multiple hazards, please
„ 
ensure you have read and under-
stood the safety instructions before
installing, operating, repairing,
maintaining or replacing acces-
sory parts, and before working
in the vicinity of the pneumatic
tyre inflator with pressure gauge.
Failure to do so can result in
serious bodily injury.
Only qualified and trained
„ 
operators should set up,
adjust or use the device.
Do not modify the device.
„ 
Modifications can reduce the
effectiveness of safety precautions
and increase the level of risk for
the operator.
Do not discard the safety
„ 
instructions – give them to the
person operating the device.
The device must be regularly
„ 
maintained, so as to verify that
16
EN
292180 Druckluft-Einstiegs-Zubehoer-Set_content_LB8.indb 16
the required introduction/safety
instructions for pneumatic tools,
rated values and markings such
as rated speed or nominal air
pressure are affixed legibly to the
device. The user must contact the
manufacturer to request replace-
ment labels or markings if this is
required.
Always use the device for the
„ 
specific applications for which it
has been designed!
Do not overload the device.
„ 
Never use hydrogen, oxygen,
carbon dioxide or any other
bottled gas as the source of energy
for this tool, since this may cause an
explosion and lead to serious injury.
DANGER! Keep hands
and other parts of the body
away from rotating parts to avoid
risk of injury.
28.11.17 14:16