BLOW DRYING
N
Curled and light
This technique is essentially for use on short and medium-length hair, soft or wavy.
u
e
For straight fringes, you will need to give more volume at the root to give the best profile.
For a longer fringe, on the other hand, the large-diameter brush will give a smoother effect. On a
damp, pre-dried fringe, place the brush under fringe, from the roots, and keep the automatic rota-
tion on to roll the section to the inside until completely dry.
e
VOLUME
d.
at the roots
y
To give more volume to all of your hair, it is important to use this tip on each section of hair.
Curls and waves are made by rolling fine sections of hair around the small-diameter
brush: the finer the section, the tighter the curl.
Always start at the nape of the neck, working progressively upwards, and finish with
the sections at the top of the head.
Place the brush alternately under the section (to dry the roots) and then over the
section (for the wave) in a relatively slow rotating movement, which will give more
volume and an effect of lightness.
The rolled sections must cool without being touched.
Once all the hair is dry, arrange the curls and waves using your fingertips.
Avoid using a comb or brush, which would spoil the effect.
THE FINISHING TOUCHES
Fringes
For a short, straight fringe, we suggest using the small-diameter brush, which
will give more movement.
Once the hair is blow dried, place the brush at the root again, under the section
(preferably the large-diameter brush), without using the automatic rotation.
Setting: drying only. Start smoothing the section against the lie of the hair for
about 3 cm from the roots and then allow the appliance to slide slowly to the tip
of the section without stretching it.
Then bring the section back to the correct side.
Replacer ensuite la mèche du bon côté.
EN