Punching And Binding With Plastic Combs - LEITZ comBIND 500e Instrucciones

1
2
3
4
5

Punching and binding with plastic combs

1. Preparations
• Set the paper stop
• Determine the comb size needed by holding the document
(including front and rear cover) in position on the comb size
scale .
K
You may also use the table on page 5 for this purpose.
• Set the punching depth
2. Inserting and opening the comb
• Place the plastic comb with the side to be opened facing upwards
into the binding mechanism
• Pull the binding lever
that the sheets can be easily inserted.
3. Punching the sheets
Tip: We recommend testing the punch setting using a blank sheet of paper
before punching the original docu ment.

Caution! To prevent damage to the motor and punching
mechanism, remove all metal parts (staples etc.) from the
document before punching. Do not punch more than 28 sheets of
80g/m² paper or two films of 0.2 mm at the same time. Empty the
cuttings tray regularly.
M
• Insert the sheets into the rear slot
• Press the punching button
• Remove the punched sheets.
4. Inserting the sheets
• Insert the punched sheets into the opened comb.
It is now possible to punch all remaining sheets (step 3) and insert them into
the opened comb.
5. Removing the finished document
• Push the binding lever
• Remove the finished document.
to the paper format used.
E
according to the comb size determined.
H
.
J
so far until the comb is opened enough so
L
.
G
.
I
backwards to close the comb.
L
7
 