Technical Data - IKEA TRADFRI Guia De Inicio Rapido

ENGLISH
ADD LIGHT SOURCES TO YOUR
STEERING DEVICE:
Before you can use your light source you'll
need to pair it with a steering device.
To add more light sources, just repeat the
steps below:
1. Make sure that your light source is
installed and the main power switch is
turned on.
2. Hold the steering device close to the
light source you want to add (no more
than 5 cm away).
3. Press and hold the pairing button
for at least 10 seconds. A red light will
shine steadily on the steering device.
Your light source will begin to dim and
finally flash one time to indicate that it
has been successfully paired.
Up to 10 light sources can be paired with 1
steering device.
Make sure to pair them one at a time. If
the light sources are close to each other,
disconnect those that have already been
paired from the main power switch.
CAUTION:
Do not use with wired dimmers. Only
controllable by IKEA Smart lighting
products.
The colour temperature can be switched
between 2200K (warm glow), 2700K
(warm white) and 4000K (cool white).
RESET YOUR DEVICE
Toggle the main switch 6 times.

TECHNICAL DATA

Operating frequency: 2405-2480Mhz
Output power: 14 dBm
Manufacturer: IKEA of Sweden AB
Address: Box 702, 343 81 ÄLMHULT
4