Transport; Assembly; Preparatory Activities; Delivery Content - Zipper Maschinen ZI-BAS205 Instrucciones De Servicio

TRANSPORT

A safety instruction designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in minor or moderate injury.
A safety notice designed in this way indicates a potentially hazardous situation
which, if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation
of the machine. Safe working depends primarily on you!
14 TRANSPORT
When handling the machine, ensure the correct posture or respectively use
suitable means of transport (such as forklift trucks, pallet trucks, etc.).
Observe any instructions and information on the transport packaging with regard to centre of
gravity, attachment points, weight, means of transport to be used and prescribed transport
position, etc.
Two persons are recommended for transport and installation.
If you transport the machine with a vehicle, ensure that it is protected against slipping, shocks
and vibration.
Never lift the machine by the worktable or by the hand wheels, but only by the frame or by the
base where the holes for fixing the machine to the ground are located. Make sure, that the blade
guard is in lower position when the machine is being transported.
When lifting, carrying and depositing the load, make sure that you are in the correct posture:
 Lifting, Depositing:
Ensure stability when lifting / setting down (legs hip width).
Lift / lower load with bent knees and straight back (like weightlifter).
Do not lift / lower the load jerkily.
 Carrying:
Carry load with both hands as close to body as possible.
Carry load with straight back.
15

ASSEMBLY

Preparatory activities

15.1.1 Delivery content

Please check the product contents immediately after receipt for any eventual transport damage
or missing parts. Claims from transport damage or missing parts must be placed immediately
after initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.

15.1.2 Workplace requirements

The workplace has to fulfill the requirements. Please consider the safety requirements. The
worktop has to be even, in level and vibration-resistant. It must be suitable at least to weight it
with double weight per square meter than the machines net weight.
The chosen workplace must have access to a suitable electric supply net hat complies with the
machines requirements. A distance of at least 0.8 m round the machine must be guaranteed.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BAS205 / ZI-BAS25038
CAUTION
NOTICE
WARNING
38