Bluetooth Function - Denver VPL-210 Manual Del Usuario

•
Carefully raise the tone arm.
•
Place the stylus vertically over the first track of the record; the turntable will
start turning automatically.
•
Lower the tone arm slowly on to the record.
•
When a record comes to the end, the turntable will stop automatically if the
auto-stop switch is in the ON position. If the switch is in the off position the
record will keep turning.
•
Lift up the tone arm and replace it on the tone arm rest.
•
Replace the protective cap on the stylus and close the tone arm lock.
•
Press the On/Off button to turn the turntable off.

Bluetooth function

•
Turn on the turntable and make sure the tone arm is on the rest.
•
The turntable will prompt to indicate entering Bluetooth function.
•
Enable the Bluetooth function on your smartphone and look for the "VPL-210"
Bluetooth device.
•
Once connected, you will hear a short voice prompt.
•
With the Previous Track, Pause/Play/Delete and Next Track buttons you can
control the choice of music on the turntable.
•
When you disconnect Bluetooth on your smartphone, you will hear a short
voice prompt.
Recording on USB stick / SD card
•
Connect a USB stick to the turntable's USB port or insert an SD card into the
card reader.
•
Place a record on the turntable (see the Chapter "Playing a record").
•
To start recording, press and hold the Mode button for about 2 seconds; a
beep tone indicates the start of the recording.
•
Place the tone arm on the record. The record is recorded in MP3 file format on
the inserted media (USB stick or SD card).
•
When the recording stops, press and hold the Mode button again for 2
seconds. Two beeps indicate the end of the recording. The recorded music will
be saved in the "RECORD0" folder on your USB stick or SD card.
•
Tracks are recorded in alphabetical order in the folder.
•
After recording, press the Mode button to play the recorded song.
•
To erase tracks from USB stick or SD card, press and hold the
Pause/Play/Delete button for 2 seconds while playing the track to be erased; a
beep tone indicates that the track has been erased.
Playback from USB stick or SD card
•
Connect a USB stick to the turntable's USB port or insert an SD card into the
card reader; the media should only contain MP3 files.
•
The turntable prompts entering USB or SD function.
4