Stanley TLM40 Manual Del Usuario página 3

Contents
• User Safety
• Charging the Battery
• Operation
• Warranty
• Error Codes
• Specifications
Retain all sections of this manual for future
reference.
User Safety
WARNING:
Carefully read the Safety
Instructions and Product Manual
before using this product. The person
responsible for the product must
ensure that all users understand and
adhere to these instructions.
WARNING:
The following label information
is placed on your laser tool to inform
you of the laser class for your
convenience and safety Figure
Symbol Meaning
V Volts
mW Milliwatts
Laser Warning
nm Wavelength in nanometers
2 Class 2 Laser
WARNING:
operation, be careful not to expose
your eyes to the emitting laser beam
(red light source). Exposure to a laser
beam for an extended time period may
be hazardous to your eyes. Do not
look into the beam with optical aids.
Charging the Battery
Fully charge the battery before initial use and
whenever the tool has not been used for 6
months or longer.
Locate the port cover on the side of the
1.
.
B
tool (Figure
Using your finger, gently pull the port cover
2.
down (Figure
Insert the small end of the USB Recharge
3.
Cable into the port on the side of the tool,
making sure to insert the flat side of the
cable into the flat side of the port (Figure
).
C 2
Insert the USB end of the cable into a USB
4.
port in a computer or USB power outlet
(Figure
C 3
Wait approximately 2.5 hours for the
5.
battery to fully charge and then disconnect
the USB Recharge Cable.
When the tool is ON, the battery level appears
WARNING: To reduce the risk of
injury, user must read this
instruction manual and the
Safety Manual.
WARNING: LASER
RADIATION. DO NOT STARE
INTO BEAM. Class 2 Laser
Product.
While the laser tool is in
).
A 4
).
C 1
).
GB
3