Matters To Check / How To Use 7 - Cuckoo CP-MN031 Manual Del Usuario

Matters To Check before Installation
Precautions for Place of Installation
Please make sure there's enough space for installation.
▶For convenience in replacing the filters, please place the
product 20 cm or further away from the wall, and place the
product where the length of the tap water supply tube is 5m or
shorter from the Tap Water Supply Valve.
If you do not use the product for a long time, close the Tap Water Supply Valve and unplug the product.
Caution
Do not use other than the following: U.S.: 120V / 60Hz; Europe: 220V / 50Hz; U.K.: 240V / 50Hz; China: 220V
/ 50Hz; and Vietnam: 220V / 60Hz. Please make sure to plug it into a proper outlet.
Matters To Check before Use
❶
Open the Tap Water Supply Valve.
▶ Turn the tap on first to check if the water is properly supplied. After that, open the Tap Water Supply Valve.
❷
Plug in the product.
▶ Check for water disconnection before plug-in.
❸
If it has been left idle for a long time or is newly installed, please leave it to drain for about 10 minutes..
❹
Empty the tray on a regular basis.
How To Use
TIP
<Standby mode> <One Cup Standby Mode> <Non-Stop Flow Standby Mode>
❶
Manual Outflow Function
▶ The filtered water will be dispensed manually.
▶ Press the Outflow button in Standby mode to dispense the water.
☞
Water will be dispensed only after pressing the Outflow button.
☞
If you press the Outflow button for more than 30 seconds, it will stop dispensing water.
Take your finger off the button and then press it again to get water.
❷
One Cup Mode (Dispensed quantity varies in accordance with water pressure.)
▶ One-cup quantity will be dispensed.
▶ Press the One Cup button in Standby mode to enter the One Cup Standby mode.
Then press the Outflow button to dispense water.
☞
If left idle for more than 7 seconds in the One Cup Standby mode, it will return to Standby mode.
☞
Pressing any of the buttons in this mode will stop dispensing the water.
☞
The default of dispensed quantity of One Cup is around 150 cc.
❸
Non-Stop Flow mode (Dispensed quantity varies in accordance with water
pressure.)
▶ The water will be dispensed continuously.
▶ Press the Non-Stop Flow button in Standby mode to enter the Non-Stop Flow
Standby mode. Then press the Outflow button to dispense water.
☞
Pressing any of the buttons in the Non-Stop Flow mode will stop dispensing the water.
☞
The default of the Non-Stop Flow time is 1 minute.
Matters To Check / How To Use
Precautions on Moving the Product
Please be careful when you move the product.
▶Please do not tilt it more than 45 degrees when moving it.
Please also make sure to plug it in at least about 30 minutes
after moving the product and filling the tank.
※
Standby mode :
The Water Purifier is plugged and
ready to be used. The Outflow LED is illuminated.
※
One Cup Standby mode :
The One Cup button is
pressed in Standby mode. The One Cup LED is lit up and
the Outflow LED starts blinking.
※
Non-Stop Flow Standby mode :
Flow button is pressed in Standby mode. The Non-Stop
Flow LED is lit up and the Outflow LED starts blinking.
The Non-Stop
7