How To Set / How To Remove and Clean Faucet Expected
Filter Replacement Cycle / Recommendations
How to Set Faucet Lighting
❶
Press the One Cup and Not-Stop Flow buttons simultaneously for 3 seconds in Standby mode to access the
settings.
❷
Depending on the selected status, the following LEDs will be lit up: one Cup LED, Non-Stop Flow LED, Button
Lock LED, and Filter Replacement LED. (The default setting is ON.)
❸
Press the Outflow button to select the desired status.
LEVEL
Faucet Lighting
1
On (Default)
2
OFF
❹
Select your desired status and press the Button Lock button.
☞
If you press any other button than the Outflow or the Button Lock button, it will be canceled and the product will return to Standby mode.
☞
If you fail to press any button for 20 seconds in the settings, it will be canceled and the product will return to Standby mode.
How To Remove and Clean the Faucet
❶
Hold the faucet and turn it clockwise to remove it.
❷
After separation, wipe out the faucet inlet with a clean cloth.
❸
Clean the separated faucet with running water.
(You may easily wipe out the dirt inside the faucet that you cannot reach by using a cotton swab, etc.)
❹
Wipe the faucet dry with a clean cloth.
❺
Insert the faucet by turning it counterclockwise.
Expected Filter Replacement Cycle
▶
The filter replacement cycle is set based on the amount of water filtered at home (10L per day), and
the status of water supply may affect the cycle.
PRE CARBON 2.0 FILTER
NANO POSITIVE PLUS FILTER
Recommendations
▶
Filtration Capacity
▶ It is to identify the life span of built-in contaminants removers such as filters. It is calculated based on removal rate of
chloroform, etc.
▶
Filter Replacement Cycle
▶ After a close review of filters, it is carefully estimated period during which a filter is expected to display its proper
performance. This is determined based on the amount of tap water filtered for drinking (10L per day for four). Thus the
cycle shortens as the amount used goes up.
The One Cup LED, Non-Stop Flow LED, Button Lock LED, Filter Replacement LED, and the
Faucet Lighting GREEN LED are illuminated.
All the lights will get turned off.
Filter Name
MINERALIZER FILTER
Display
Expected Replacement Cycle
4 months
12 months
12 months
9