Uline H-7906 Guia De Inicio Rapido página 3

8. Turn the step stand over onto a level surface.
(See Figure 7)
Figure 7
9. Tighten all of the hex nuts onto hex head cap screws.
All of the braces and connections should be tight
and not loose.
PAGE 3 OF 9
ASSEMBLY INSTRUCTIONS CONTINUED
1-800-295-5510
uline.com
DANGER! Inspect the step stand for any
permanent deformation, corrosion, degradation
or any condition impairing protective capability.
If any of these conditions are suspected,
remove from service with warnings prohibiting
use prominently displayed on the step stand
until step stand can be replaced.
0521 IH-7906