Joie i-Snug Manual De Instrucciones página 7

5. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
9
installed correctly, red means it is installed incorrectly.
!
The load leg has 24 positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
9
The completely assembled base is
shown as
10
!
The ISOFIX connectors must be
attached and locked onto the
-1
ISOFIX anchor points.
10
!
The load leg must be installed
correctly with green indicator.
-2
10
11
-3
9
3
1
2
10
1
6. Push the infant carrier module
down into the base
enhanced child restraint is secure,
the enhanced child restraint
indicator shows green.
!
Pull up on the infant carrier
module to be sure it is securely
latched into the base.
7. To release the infant carrier
module, pull the infant carrier up
-2
while squeezing the infant
13
carrier release button.
2
11
, if the
11
12
12
13
2
-1
13
1
12