DeWalt DW217 Traducido De Las Instrucciones Originales página 21

2. Insert a screwdriver into the chuck and remove the chuck
retaining screw 8 by turning clockwise.
3. Tighten an hex key into the chuck and strike it with a
hammer as shown.
Prior to Operation
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
OPERATION
Instructions for Use

WARNING:
• Always observe the safety instructions and
applicable regulations.
• Be aware of the location of pipework and wiring.
• Apply only a gentle pressure to the tool. Excessive
force does not speed up drilling but decreases tool
performance and may shorten tool life.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
Proper Hand Position (Fig. A, G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand under the the housing,
with the other hand on the main handle
Switching On and Off (Fig. D)
• To run the tool, press the variable speed switch
pressure exerted on the variable speed switch determines
the tool speed.
• To stop the tool, release the switch.
Lock-on Button
DW217/DW221/DW226/DW236/DW246
• If necessary, press the lock-on button
operation and release the switch. The lock-on button works
only at full speed.
• To stop the tool in continuous operation, press the switch
briefly and release it. Always switch off the tool when work is
finished and before unplugging.
MAINTENANCE
Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

Lubrication
Your power tool requires no additional lubrication.
Cleaning


Optional Accessories

Consult your dealer for further information on the
appropriate accessories.
Protecting the Environment
6 .
1 . The
be recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
for continuous
2
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury.
WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.
WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
part of the tool into a liquid.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
EngLIsh
WALT recommended
e
19