Operation - Ryobi CID120L Manual Del Operador

Destornillador de impacto de 12 v
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving long deck screws while building a deck
 Driving carriage bolts into deck posts
 Driving Tapcon
screws into block walls and concrete
®
 Driving screws into metal studs
TO INSTALL/ REMOVE BATTERY PACK
See Figure 1, page 8.
To install the battery pack:
 Place the direction of rotation selector in the center
position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
To remove the battery pack:
 Depress the latches on each side of the battery pack.
 Remove the battery pack from the tool.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.

OPERATION

VARIABLE SPEED SWITCH TRIGGER
See Figure 2, page 8.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it OFF,
release the switch trigger and allow the coupler to come to
a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 2, page 8.
The direction of bit rotation is reversible and is controlled by
a selector located above the switch trigger. With the impact
driver held in normal operating position, the direction of
rotation selector should be positioned to the left of the switch
trigger for forward rotation. The direction is reversed when
the selector is to the right of the switch trigger.
NOTICE:
To prevent gear damage, always allow coupler to come to
a complete stop before changing the direction of rotation.
To stop, release switch trigger and allow the coupler to come
to a complete stop.
SPEEDLOAD +
See Figure 3, page 8.
The SPEEDLOAD +
designed to accept any 1/4 in. hex bits.
 Lock the switch trigger by placing the direction of
rotation selector in the center position.
 Remove the battery pack from the impact driver.
 Insert the bit into the chuck and push as far as possible
until the chuck locks onto the bit.
NOTE: Pull on the bit to make sure it is secured in the
coupler. There may be some play in the installed bit; this
is normal.
 To remove a bit, push rubber collar forward, and then pull
the bit straight out of the chuck.
WARNING:
Make sure the bit is secured in the coupler before using
the impact driver. Failure to do so could cause serious
personal injury.
5 — English
SYSTEM
SYSTEM is a quick change chuck

Publicidad

Tabla de contenido
loading

Tabla de contenido