Tabla de contenido
Publicidad
4. Next, the motor's square block will appear (see Screen 6).
Now you've completed programming the first motor, you can
press
to add operation settings for the next step.
Operating motor
Speed
Length of time
(seconds)
5. If you want to modify the program you've just edited, press
the motor block
and you will go to the next page.
6. Here you can make adjustments, edits, or even delete this
program. Just press
on the lower left corner to delete.
If you want to delete a series of programs, just press
the right.
7. If you want to delete a page of programs, just press
upper left.
If you want to back to the set you saved last time, just press
.
WRITE MUSIC AND PAUSE PROGRAM
To make your own musical compositions follow these steps:
1.
If you want to write a music program, press
2. ou will be taken to another window where you can design
your music or voice program. Press the Do-Re-Mi and other
musical symbols to write a piece of music. You can paste the
music program into the middle of the motor operation pro-
gram.
3. Use
to drag and set the length of the mu-
sical symbols, then press
to confirm.
4. The final option is to
write a pause pro -
gram. Press
and a
new window will ap-
pear.
22
Screen 6
on
on the
(see the right screen).
5. Use
to drag
and set the length of the pause.
Press
to confirm.
HOW TO ADJUST THE PARAMETERS OF THE ULTRASONIC SENSOR
1. Return to the first editing page (right screen).
2. When you press
, the upper left corner will display the sen-
sor's read distance.
If your loop contains an edited program, the model will com-
plete the action before reading.
3. Afterwards, you will see the
screen display (see screen 1). The
image has turned from 0 rotations
to 18, meaning the distance be-
tween the model and obstacle is 18
cm.
Screen 1
4. Use
to set limits, such as less than 10 cm, or more than
30 cm (right diagram). You can drag the icon to decide what
actions are executed at different distance conditions. In other
words, you can set the sensor to detect at specific distances and
to execute specific actions.
Ex:
Initiate the model.
Set the limit at a distance between 0-30 to
execute these specific actions.
Set to execute specific actions at
a distance of 31-50.
The check mark
represents you want a full loop of these specific actions (not checking it
means to stop after execution is complete)
5. If you want to increase the distance of the limit, simply use the
icon
to setup. See screen 4
6. As shown in the image on the right, the seven limits have
completed setup.
When you have over four limits, scroll
or more options.
See screen 5
Screen 2
Screen 3
Screen 4
Screen 5
23
Publicidad
Tabla de contenido
