Juguetronica SMARTBOTS Manual De Instrucciones página 13

NOTES FOR ASSEMBLY
a c
b
1. Use the "A" end of the Peg/Axle remover to
pull off the peg (Pic. a).
2. Use the "B" end of the Peg/Axle remover to
pull out the axle (Pic. b).
3. Use the "B" end of the Peg/Axle remover to
pull off the button fixer (Pic. c).
HOW TO REMOVE THE BATTERY
Use the "B" end of the peg/axle remover to take out the
battery.
You can label the battery box with red and blue symbols
to help you keep track of which motor is operating ac-
cording to your program.
ultrasonic sensor
24
When attaching a gear or a tire to the
framework with a drive axle, be sure to
keep a gap of about 1 mm between the
gear or the tire and the framework to de-
crease the friction caused in operation so
that smooth motion can be assured.
The centre of the BT Receiver is connected to the
The left side connects to motor 1
The right side connects to motor 2
FLEXIBLE DRIVE SHAFT
The transmission shaft is between the gear and gear shaft and provides power. Standard
transmission shafts are as shown in picture 1.
Flexible drive shafts have the characteristic of being easily adjustable over distance and are
greatly changeable, as shown in pictures 2, 3, and 4.
Another advantage is its flexibility. It can absorb impact and reduce vibrations. That is why
flexible drive shafts are commonly used in transportation vehicles such as cars and scooters.
Picture 1 Picture 2 Picture 3 Picture 4
25