How To Operate; Helpful Tips - smart SSCM700 Instrucciones Y Recetas

HOW TO OPERATE

• Place the SMART Single Snow Cone Maker on a stable, waterproof surface near an electrical
outlet before starting.
• Always make sure that the cord is away from a water source.
• Remove the Snow Cone Holder from the base of the unit and reattach the Snow Cone Holder
so that it faces upward.
• Before plugging in the unit, add approximately 4-5 medium size ice cubes to the Ice Hopper
by removing the Lid. In order to do so, turn the Lid clockwise, lift and remove.
• Plug in the unit.
• Place a cone in the Snow Cone Holder.
• When you are ready to make a snow cone, place the Lid back on the unit and turn Lid
counter-clockwise to lock.
• The Ice Hopper will immediately begin shaving the ice. Rotate cone with your hand as
needed to collect snow ice.
• To stop the Ice Hopper from shaving ice, turn the Lid clockwise.
• Repeat the process until you have shaved the amount of ice desired.
• Unplug unit from outlet when finished.
• Total operation time is approximately 5 minutes..
By following these simple instructions, your SMART Single Snow Cone Maker will be fun for
friends, family and kids of all ages!

HELPFUL TIPS

ICE CUBES
Ice cubes should sit a short while before putting them in the shaving unit. If ice has a frosty
appearance, it is too hard to shave. Let ice sit until it is translucent and wet to the touch. Then it is
ready to put in the Ice Hopper.
SHAVED ICE
While ice is shaving, it will empty from Spout and may get on surface and floor around the SMART
Single Snow Cone Maker. This is normal. In order to prevent messes:
• Place unit on a waterproof surface while in use.
• Rotate cone in holder as needed in order to fill cone evenly.
• After you are finished making snow cones, make sure Ice Hopper is empty so that ice does
not melt onto surface.
SHAKING
If the unit begins to shake, make sure that the suction cups on the bottom of the unit are firmly
pressed into table or countertop.
6