LD Systems STINGER G3 Manual De Usuario página 16

LDEBG3SCP
(suitable for LDEB82G3, LDEB82AG3, LDEB102G3, LDEB102AG3)
1 Traverse clamp with adjustable T-screw and flange for mounting pin (only for mounting on horizontal traverses).
2 Mounting pin with M10 thread and wing nut.
3 Adapter for attaching the clamp to square-section tubes.
4 Remove the M10 screw on the top of the speaker.
5 Remove the M10 wing nut from the mounting pin (No. 2) and screw it fully into the M10 thread on the top of the speaker.
6
Attach the traverse clamp to a traverse with the adjustable T-screw in a suitable position and ensure a firm grip.
7 Loosen the locking screw so far that the flange on the underside of the clamp can accept the mounting pin (do not remove the bolt).
8
Push the spring-loaded locking pins on the side of the clamp into the housing so that the flange on the underside of the clamp can accept the
mounting pin and push the pin all the way into the flange. Release the pressure from the locking pin and keep hold of the speaker until you are
certain that the mounting pin is fully engaged. Rotate the speaker to achieve the desired dispersion and secure the connection by tightening the
locking screw No. 7.
5
4
16
1
2
3
8
6
7