LD Systems STINGER G3 Manual De Usuario página 7

LDEBG3WMB
(suitable for LDEB122G3, LDEB122AG3, LDEB152G3, LDEB152AG3)
Screw the adjustable U-bracket (in a suitable position) to a load-bearing wall (A). Use suitable screws and plugs etc. to ensure secure mounting. The
35mm mounting stud can be installed on the bracket at four different distances from the wall. Select the appropriate position for the speaker and
screw it tightly to the bracket (B, position the supplied rubber ring on the mounting stud). Remove the M10 screw on the top of the loudspeaker and
lift the speaker into the bracket so that the 35mm mounting stud sits in the 0° flange of the speaker (C). Now set the adjustable side of the bracket
to the appropriate size for the speaker and secure it with the two screws on the side of the bracket (D). Using the supplied M10 T-screw in the correct
position directly opposite the mounting stud, position the speaker at the desired angle in the bracket (E, place supplied rubber washer between bracket
and speaker. For permanent installation an M10 Allen screw is supplied). For traverse-installation, mounting holes for traverse clamps are situated at
positions corresponding to speaker size (F).
A
F
A
F
B
E
D
C
7