Electric Installation - Texi ART AUTO Manual De Usuario

CAUTION
Basic requirements concerning working place and machine use
· Pay attention to clothing. Let-down hair or loose clothing can be caught by the machine's mobile elements.
· Take care not to damage the power supply cable.
· When the machine is not in use, disconnect it from the power grid.
· Take care not to turn-on the machine accidentally.
· In case of even the slightest damage, always check if the damaged part requires replacement.
· Never install on the machine attachments and accessories other than those recommended by the manufacturer and supplier.
· Do not perform machine modifications independently.
· Do not leave near the machine unattended bystanders or children.
· Secure the table so that it will not move when tilting back the machine head, or during other maintenance work. When tilting
machine, always use both hands
· Secure the table so that it will not move when tilting back the machine head

Electric installation

Check if the supply voltage in the electric socket corresponds to the data on the machine's rating plate 1-phase voltage 230V
50Hz.
Check the correctness of electric connections in the plug and electric socket, observing electric shock safety countermea-
sures.
Be to connect the ground. If the ground connection is not secure, you run a high risk of receiving a serious electric shock, and
problems with correct operation may also occur.
Do not use extension power cords.
Apply the valid electrical and Industrial Safety norms.
ATTENTION – all work related to the electrical installation must be carried out by a qualified electrician.
Any fluctuations in the power supply voltage should be within ±10% of the rated voltage for the machine. Voltage fluctuations
which are greater than this may cause problems with correct operation.
Use the sewing machine in an area which is free from sources of strong electrical noise such as electrical line noise or static
electric noise. Sources of strong electrical noise may cause problems with correct operation.
After finish your work always switch off the machine and disconnect it from power supply.
In the event of an electrical storm, turn off the power and disconnect the power cord from the wall outlet.
27
EN TEXI ART AUTO operation manual