3. Installation
1. Foot controller installation
Connect speed controller (1) to the table top and then by
using connecting rod (2) assemble it with foot controller
(pedal).
Connect wires with control box at the back of machine
head.
3. Oil pan installation
Rubber cushion (1&2) should be placed in the corners.
Mount oil plan (3) as shown on the drawing.
5. Installation of the machine head on the table top.
Place metal hinges (1) in the openings of the machine
head and then install machine (2) on the table top.
2. Electronic knee lifter installation
Connect electronic foot lifter (1) to the table top.
Into the bracket (2) mount knee lifter lever (3).
Connect wires with control box at the back of machine
head.
4. Rubber hinges installation
Install two pieces of rubber hinges (1) to the correct
openings as shown on the drawing. Secure with nail (2) -
two pieces on each hinge.
6. Thread stand installation
Tighten correctly all elements of thread stand (1).
Tighten the nut (4) so that the two rubber cushions (2) and the
washer (3) are clamped and secured so that the thread stand
(1) does not move.
31
EN
TEXI ART AUTO operation manual