Troubleshooting - METRO PROFESSIONAL GSC3336 Manual De Instrucciones

• Wipe the outside and inside of the appliance
with a dry and soft cloth daily. If the appliance
is very dirty, wipe with a soft damp cloth and a
little mild detergent. Dry with a soft dry cloth.
• Clean the shelves thoroughly with a soft damp
cloth and a little mild detergent at least once a
month. Dry with a soft dry cloth.
• To ensure a trouble-free performance and to
avoid excessive electricity consumption, clean
the condenser every three months using a
vacuum hose. When using the appliance under
special conditions, clean the condenser more
often. Clean the condenser coil in the same way
at least once per year. If the condenser coil is
not cleaned at least once per year, the efficiency
of the appliance will decrease significantly.
• Clean the gaskets and seals with a dry and soft
cloth. Check them for debris to ensure the door
always close properly.
• The appliance may only be used again or stored
after it is dried completely.
Defrosting
• The appliance will defrost itself automatically
every 4 hours.
• When the defrosting is finished, the appliance
will enter into dripping phase. The water will
drip into the water collection container and then
evaporate there automatically.
• You can also start a manual defrosting process
by keeping the defrost button
button pressed for approx. 6 seconds.
Note: During the defrost process, the appliance
will slightly raise the temperature inside the cooling
compartment, so that the developed ice can melt.
This process is not harmful to the products stored in
the appliance and will only take 20 minutes.
Storage
• Before storing, remove all foodstuffs from
the appliance, disconnect it from the supply
and clean the appliance and its accessories
thoroughly.
• Store the appliance in a dry, protected
environment, preferably at room temperature.
• To protect the appliance from dust, cover it
with a cloth that allows air circulation inside the
appliance.
4.
WARNING!
•
•
•
Problem
Appliance
does not
operate.
and SET
Appliance
does not
achieve
required
temperature.
- 14 -

Troubleshooting

In case of failures or malfunctions, always
unplug the appliance immediately.
Only perform the steps described in this
instruction manual! All further inspection,
maintenance and repair work must be
performed by an authorized service center or a
similarly qualified specialist.
Should you require spare parts, always obtain
them from an authorized seller. Do not use
spare parts that are not recommended by the
manufacturer!
Possible
cause
Power plug
not connected
to electrical
outlet.
Supply cord is
damaged.
Control panel
is not set
correctly.
Appliance is
located near
heat sources.
Stored
beverages or
other objects
prevent
proper closing
of door.
Cooling
compartment
overloaded,
filled with hot
beverages or
filled in a way
that prevents
proper air
circulation.
Door opened
and closed
too often.
GB
Solution
Connect power
plug to a suitable
electrical outlet.
Plug it in tightly.
Have supply cord
replaced by the
manufacturer, its
service agent or
similarly qualified
persons.
Set temperature
with control panel
as described in this
manual.
Move appliance
well away from heat
sources.
Reorder contents
of cooling
compartment or
remove several
items to allow door
to close.
Remove several
items, remove
hot beverages or
reorder contents
of cooling
compartment to
allow air circulation.
Keep door closed
for a while.