Installation; Location And Assembly; Mains Connection; Audio Input Connections - Ecler CA200z Manual De Instrucciones

Ocultar thumbs Ver también para CA200z:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. INSTALLATION

3.1. Location and assembly

The CA200z can be installed on a tabletop, in a standard 19" wide rack cabinet or in a
standard 9.5" wide half-rack cabinet. Any of these installation options is possible using the available
rack installation accessories (kit of 2 2UHRMKIT supports, not included as standard).

3.2. Mains connection

The amplifier is powered by alternating current through its internal power source: 90-
264VAC and 47-440Hz.
The amplifier's AC power cable must be earthed through its mains cable (earth resistance
Rg = 30or lower). The working environment should be dry and completely dust-free. Do not
expose the unit to rain or water splashes. Do not place liquid containers or incandescent objects
such as candles on top of the unit.
Always
connecting/disconnecting the amplifier. There are no elements that can be manipulated
by the user inside the amplifier.
To avoid buzzing, do not allow the power cable to intertwine with the shielded audio
cables that transport the signal.

3.3. Audio input connections

The CA200z accepts two types of signals in its input channels:
Microphone (MIC): with balanced Euroblock-type connections on the rear panel or
jack (MIC2) connections on the front panel that can accept a signal level between -20
dBV and –50 dBV with adjustable sensitivity through its ADJ control
Note: The microphone inputs have phantom power to supply condenser microphones, activated
by the internal jumper (see 10. CONFIGURATION DIAGRAM section). This option comes
disabled (OFF) by default or from the factory.
Line signals (LINE 1 to LINE 4): equipped with a non-balanced mini jack stereo
connection on the front panel (LINE 2) or double RCA on the rear panel (LINE1 to
LINE4). They can admit nominal signals of -6 dBV and 0 dBV, with input sensitivity
that can be adjusted through internal jumper (see section 10. CONFIGURATION
DIAGRAM). These can be used to connect signals from CD players, radio tuners,
mixing consoles, media players, PC and tablet audio outputs, etc.
Note: Turntables CAN NOT BE CONNECTED directly to this device because none of the inputs
have an RIAA preamp.
Active audio sources are selected/deselected by a short press of the front panel keys
labelled LINE 1 to 4, MIC1 and MIC2. The possible source selections are:
LINE SELECTION:
-Pressing one of the LINE1 to LINE4 keys activates the corresponding line
input (LED lit = selected source)
-Two or more sources of this type cannot be selected simultaneously: when
one line input is selected, the previous one is deselected
6
unplug
the
unit
from
the
mains
supply
before
working
on
or

Publicidad

Tabla de contenido
loading

Tabla de contenido