Before You Begin - Kohler K-201 Manual Del Usuario

Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few
minutes to review this manual before you start installation. If you
encounter any installation or performance problems please don't
hesitate to contact us. Our phone numbers and website are listed on
the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Observe all local plumbing and building codes.
Shut off the main water supply.
Inspect the tubing for any sign of damage. Replace if necessary.
If possible, install this faucet before installing the sink.
If installing to other than a Kohler Side Spout faucet, you will
need to purchase an adapter to connect the outlet of the filter to
the faucet inlet.
This system and installation must comply with state and local
laws and regulations.
Only install the filtration system to a cold water supply. Do not
use with hot water systems.
Filter cartridges should be replaced every 3-6 months, when
capacity has been exceeded, or when a noticeable decrease in flow
is observed.
If needed, clean the exterior of the unit with mild soap and water.
Do not use chemical cleaners. Do not connect to a dishwasher.
Do not install the filtration system to a water line whose pressure
exceeds 125 psi (862 kPa).
Make sure the unit is not installed with hoses under tension. Do
not overtighten connections.
Keep the filter and plastic cartridges away from heat or flame.
Do not install the unit where the temperature may drop below
freezing.
This unit is designed to be installed under a sink. Make sure that
the bottom of the filter cartridge is at least 2" (5.1 cm) from the
floor of the cabinet.
Kohler Co. reserves the right to make revisions in the design of
faucets without notice, as specified in the Price Book.
INSTR 2026 0404
1014875-2-F 2 Kohler Co.