Electrical Safety - Black+Decker SVA420B Traducción De Las Instrucciones Originales

ENGLISH
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate. Never attempt to
replace the charger unit with a regular
mains plug.
Symbols on the charger
+
Read all of this manual carefully before using
#
the appliance
w
This tool is double insulated; therefore no
earth wire is required. Always check that the
power supply corresponds to the voltage on
the rating plate.
Short circuit proof safety isolating transformer.
The mains supply is electrically separated
from the transformer output.
SMPS
$
Indication of polarity.
The charging base is intended for indoor use
only.
Labels on appliance
+
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before
using the appliance
J0D-S-180050GS
J0D-S-180050GS
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Dust bowl release button
3. Dust bowl
4. Chassis on/off power switch
5. Brush control switch
8
(Original instructions)
6. Upper handle
7. Main chassis
7a. Chassis release button
8. Floor head
9. Floor charging base
9a. Tool storage
10. Charger
11. Brush tool accessory
12. Crevice tool accessory
Use
Switching on and off (Fig. A)
To switch on, press the on/off switch (1) located on the
u
handle of the main unit (1), or alternatively on the chassis
handle (4).
To switch off, press the on/off switch (1) or (4).
u
Using Accessories (Fig. B)
The appliance is supplied with a brush tool (11) and a
u
crevice tool (12).
Fit the chosen accessory into the front of the appliance as
u
shown in Figure B.
Fitting the upper handle to the main chassis
(Fig. C, D)
The stick vac chassis is supplied in 2 parts, the upper han-
u
dle (6) and the lower chassis (7), but they are connected
by a wire.
Slide the upper handle (6) into the main chassis (7) as
u
shown in figure C.
Ensure the wire is not trapped.
u
Secure with retaining screw (13) as shown in figure D.
u
Fitting the floor head to the Chassis
(Fig. E)
Slide the main chassis (7) into the floor head (8) until an
u
audible click is heard, as shown in figure E.
Fitting the vacuum to the Chassis
(Fig. F, G)
Slide the vacuum, nozzle first, into the chassis (7) until an
u
audible 'click' is heard as shown in figure F.
To release the vacuum from the chassis press the chassis
u
release button (7a) and lift clear.
The appliance can now be operated via the on/off button
u
(4) on the handle (6). This also allows you to utilise the
beater bars via the 'brush on' control (5) as shown in
figure G.
Charging (Fig. H)
The charging base (9) will need to be securely fastened to
u
a wall.