Electrical Safety - Black+Decker DVJ325BFSP Manual De Instrucciones

ENGLISH
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
appliance.
#
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
$
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code:
6
(Original instructions)
+
Read all of this manual carefully before
using the appliance
Only use with charger S010Q 14
S010Q 14
Features
This tool includes some or all of the following features.
1. On/off power switch
2. Handle
3. Nozzle
4. Pull out crevice tool
5. LED charging indicator
6. Dust bowl
7. Dust bowl release button
8. Charging base
9. Detachable push in brush accessory
10. Power head
Use
Switching on and off (Fig. A)
Press the button (1) to turn on, the unit operates
u
in slow speed, low power mode, conserving the
battery life.
(1)
Press the button again, and the unit goes to a BOOST
u
mode.
(1)
Pressing the button
u
Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (4) as shown in figure C, until
u
it clicks in place. The push in brush (9) can be fitted if
required for dusting and upholstery cleaning.
To retract the crevice tool (4) press the crevice tool release
u
button (4a) allowing it to return to its normal position
(Fig. B).
Attaching the power head (Fig. D)
Slide the nozzle (3) into the opening of the power head
u
(10), ensuring that the connectors (10a) engage with the
recesses (3a). An auadible click will be heard.
Detaching the power head (Fig. E)
Push th power head release button (10b).
u
Lift the main dustbuster unit from the power head (10).
u
Removing the beater bar from the power head
for cleaning (Fig. F)
Press the beater bar release button (10c).
u
Lift the beater bar (10d) up and out of the power head.
u
The beater bar can now be freed from any hair and accu-
u
mulated debris.
again will turn the product off.