Introduction; Cabling And Setup - Palmer MONICON XL Manual De Usuario

INTRODUCTION

The Palmer Monicon XL is the perfect tool for controlling multiple audio sources and studio speakers thanks
to its ergonomic console layout. It features three analog stereo inputs, an S/PDIF input, and outputs for
three pairs of monitors with individual volume controls that allow for level adjustment. There is also a mono
output for a special mono speaker or subwoofer. The inputs and outputs can be conveniently controlled
using illuminated buttons. A correlation display provides visual information about the mono compatibility of
your stereo mixes. Certain functions can be adjusted and their settings saved to help you work the way you
want.
Additional features:
• Latency-free and no sound coloration, thanks to analog signal routing
• Two separately controllable headphone outputs with selector switch for main or cue signal
• Integrated talk-back microphone with illuminated button and adjustable dimming function
• Mono button, mute function, and large main volume control
Scope of delivery:
External power supply, user manual

CABLING AND SETUP

Before putting the device into operation, make sure to observe the technical data for all components, such
as the maximum output level of player devices and the maximum input level of the monitor controller and
monitors! In case of uncertainty, consult an experienced studio technician. Use high-quality and, if possible,
balanced cables for cabling. In the following, you will find information about cabling and putting the mon-
itor controller into operation with active studio monitors. The procedure can also be applied to the cabling
and setting up with a power amp and passive studio monitors.
• Before you begin installing the cables, turn off any devices that you want to connect to the monitor con-
troller and set the volume of all devices to minimum.
• After installing the cables, turn on the connected monitors and headphone amplifiers as the last devices.
• Start playback on the desired player device and activate the appropriate input (INPUT SELECT IN 1 to IN
3). Then check the input signal using the 8-segment LEFT and RIGHT level indicators. If necessary, adjust the
display to the input signal level (for description, see point 16).
• Make sure that the controller's MUTE, DIM, and TALK functions are not activated.
• Now activate the monitor output (OUTPUT SELECT OUT 1 to OUT 3) to which your monitors are connected
and turn the corresponding GAIN control above the output all the way clockwise (maximum).
• Set the MAIN volume control to the 12 o'clock position and carefully increase the volume of the monitors
to the desired monitoring volume, making sure that the monitors are equally loud. Repeat these same steps
to adjust a subwoofer's volume to the volume of the monitors.
• Keep the levels of various player devices and pairs of monitors at the same level to avoid sudden jumps in
volume when switching signal sources and monitor outputs.
5