Palmer MONICON XL Manual De Usuario página 9

OUTPUT SELECT OUT 1 - OUT 2 - OUT 3
10
Buttons for selecting OUT 1 to OUT 3 line outputs on the back of the device (No. 5). The button corre-
sponding to the active line output illuminates. You can choose between three modes of operation when
selecting the line outputs.
Mode of operation A: All line outputs can be selected and activated at the same time (factory default).
Before changing the setting, switch off all connected monitors and headphone amplifiers. To select the
mode of operation A "Multi mode," switch off the monitor controller, press the OUT 1 button on OUTPUT
SELECT, and hold down the button until the monitor
controller has been switched on again.
Mode of operation B: A single line output can be freely selected and activated. The previously activated
line output will be deactivated upon selecting another line output. To select the mode of operation B "In-
dividual mode," switch off the monitor controller, press the OUT 2 button on OUTPUT SELECT, and hold down
the button until the monitor controller has been switched on again.
Mode of operation C: Line output OUT 3 can be switched on or off
independently of OUT 1 and OUT 2. OUT 1 and OUT 2 can be selectively activated, but not both at the
same time. The previously activated line output will be deactivated upon selecting the corresponding line
output. To select the mode of operation C "Combined mode," switch off the monitor controller, press the
OUT 3 button on OUTPUT SELECT, and hold down the button until the monitor controller has been switched
on again.
CUE SOURCE IN 1 - IN 2 - IN 3
11
Illuminated buttons for selecting the IN 1 to IN 3 signal source for the CUE L/R line output. The button
corresponding to the active line input illuminates.
CUE OUTPUT
12
Volume control for the CUE line output (UNBAL. LINE OUTPUTS CUE).
MAIN
13
Volume control for the balanced line outputs BALANCED MONITOR OUTPUTS 1 to 3. Keep the levels of
various signal sources at a similar level to avoid sudden jumps in volume when switching signal sources.
MONO
14
Push the MONO button in order to monitor the output signals of the line outputs BALANCED MONITOR
OUTPUTS 1 to 3 and the headphone outputs 1 and 2 (MAIN signal) in mono. It is easy to control how a mix
sounds in mono because many clubs and bars use sound systems in mono mode. It is also always advisable
to listen to a stereo mix in mono because it will allow you to better identify problems with the phasing and
to also rectify them.
The MONO function does not affect CUE channel's signal.
The modes of operation for the MUTE, TALK, INPUT SELECT and OUTPUT SELECT buttons can be reset to
the factory default by switching off the monitor controller, pressing MONO, and holding it down until the
monitor controller has been switched back on again. Before changing the setting, switch off all connected
monitors and headphone amplifiers.
MUTE
15
Mute function for the output signals of the line outputs BALANCED MONITOR OUTPUTS 1 to 3 and the head-
phone outputs 1 and 2 (MAIN signal). The mute function does not affect CUE channel's signal.
You can choose between two modes of operation for the MUTE function.
Mode of operation A (factory default): "latching" (switch): Push the MUTE button once to activate the
function and briefly again to deactivate the function. The MUTE button illuminates when the mute function
is activated.
Mode of operation B: "momentary" (button): The MUTE function is only active as long as the MUTE button
is pressed. The function automatically deactivates upon releasing the button. The MUTE button illuminates
when the MUTE function is activated.
Before changing the setting, switch off all connected monitors and headphone amplifiers.
To select the mode of operation B, switch off the monitor controller, press the MUTE button, and hold it
down until the monitor controller has been switched on again.
9