Connections, Control, And Display Elements; Power On/Off - Palmer MONICON XL Manual De Usuario

CONNECTIONS, CONTROL, AND DISPLAY ELEMENTS

2
1
6
POWER
1
Low-voltage socket to supply power to the device. Please use only the provided power adapter. The
strain relief fitting is located next to the socket. Use the strain relief for the power adapter's flexible cable to
protect the device's low-voltage socket and the power adapter's low-voltage plug from damage and to
avoid pulling out the plug inadvertently.

POWER ON/OFF

2
On/off switch for the device power supply.
BALANCED INPUTS IN 1 & IN 2
3
Balanced stereo line inputs with 0.25 inch jack sockets (IN 1 L+R, IN 2 L+R).
INPUT 3
4
Unbalanced stereo line input with L + R cinch sockets, one 0.14 inch stereo jack socket and one coaxial
S/PDIF input. The analog cinch inputs and 0.14 inch jack socket can be used at the same time. In this case,
the volume balance must be set on the respective player devices. The digital S/PDIF input can also be
used. The control panel on the top of the device is used for analog and digital signal source switching and
the level adjustment for IN 3 AUX.
BALANCED MONITOR OUTPUTS 1 - 2 - 3
5
Balanced outputs for connecting active studio monitors and power amps with passive studio monitors. All
three outputs are equipped with 0.25 inch TRS jack sockets. In addition to the two L and R sockets, Output
3 provides a mono-summed SUM output for connecting an additional monitor with mono signal or a sub-
woofer. If necessary, the output level can be configured separately for all three outputs on the correspond-
ing GAIN controller and thus adapted to the connected monitor system.
UNBAL. LINE OUTPUTS MAIN - CUE
6
Unbalanced outputs with 0.25 inch jack sockets
MAIN L/R - connection available for external recording device, such as a tape recorder or a digital stereo
recorder. The signal which is selected as the input signal on the control panel for INPUT SELECT (IN 1 to IN
3) is output. The signal is tapped before the MAIN volume control. It therefore functions independently of it
and is not influenced by the MUTE, MONO, DIM, and TALK functions.
CUE L/R - connection available for an external headphone amplifier. The signal which is selected as the
signal source on the control panel for CUE SOURCE (IN 1 to IN 3) is output. Adjust the signal volume with the
CUE OUTPUT volume control on the control panel. The signal is not influenced by the MUTE, MONO and DIM
functions, while the TALK function retains its full scope of features.
5
3
4
7