Tabla De Contenido; Ce Declaration Of Conformity - FAAC 724 D-24V Instrucciones Para El Uso

1. GENERAL CHARACTERISTICS
2. TECHNICAL SPECIFICATIONS
3. PRELIMINARY SETTING-UP
4. CONNECTIONS AND OPERATION
4.1. TERMINAL BOARD M1
4.2 M2 TERMINAL BOARD
4.3 M3 TERMINAL BOARD
4.4 TERMINAL BOARD M4
5. INSTALLING A RECEIVER CARD FOR REMOTE-CONTROL
6. CONTROL LEDS
7. OPERATION OF DISPLAY
8. ADJUSTING THE OPERATING PARAMETERS
9. PROGRAMMING
10. OPERATION OF ELECTRONIC CLUTCH
11. PROTECTION FUSES
12. CONNECTION LAY-OUT
13. FUNCTION LOGICS
15. HOW TO SECURE THE BOARD
Manufacturer: FAAC S.p.A.
Via Benini, 1 - 40069 - Zola Predosa- Bologna - ITALIA
Address:
Declares that: Control unit mod. 724 D
• conforms to the essential safety requirements of the following EEC directives:
73/23/EEC and subsequent amendment 93/68/EEC.
89/336/EEC and subsequent amendment 92/31/EEC and 93/68/EEC
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by FAAC S.p.A.).
Bologna, 01-01-2004
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the
The symbol draws your attention to the notes on the characteristics and operation of the product.
INDEX

CE DECLARATION OF CONFORMITY

Notes on reading the instruction
automated system.
11
page.12
page.12
page.12
page.13
page.13
page.13
page.14
page.14
page.14
page.14
page.15
page.15
page.16
page.16
page.16
page.17
page.18
page.20
Managing Director
A. Bassi