Wearing Options - Disty Notruf NEO Instrucciones De Operación

Charging mode LED/tone
Connect to the Signal tone,
charging lead red LED lights up once
Connected to the The red LED flashes during
charging lead the charging process and
EN
disappears when the charg-
ing process is complete
(flashing rhythm once a
second)
Mode LED/tone
Battery low Red LED flashes every
30 secs., signal tone
Subscribed, Green LED flashes once
registered every 10 secs.
Subscribed, out- Red LED flashes every
side the range/ second
no base station
DECT Green LED lights up
connection
Alarm Red LED flashes quickly
Incoming call Green LED flashes,
signal tone once
Range (limit) Red LED flashes quickly,
signal tone
28 Operating instructions

Wearing options

distyNotruf
The NEO can be worn on the
body in three different ways:
Option 1:
distyNotruf
Attachment the
to the wrist
The wrist strap is pre-assembled in the
distyNotruf
factory. The
NEO
attached to the wrist so that the charging
socket faces the body. The shorter end of
the strap should be pulled through the
opening of the other half of the strap and
tightened against the wrist. Both pins on
the closure must be pressed into the
opposing holes and clicked into place.
In case of disassembly, from the outside
of the hole, press with a pin or paper clip
on the spring bolt so that this is pressed
together and can be removed from the
hole. If the length and closing mechanism
of the pre-assembled armband are not
appropriate, you can replace it with the
second armband provided.
Operating instructions
NEO
should be
29
EN