Reset/Unsubscribe; Technical Data; Declaration Of Conformity - Disty Notruf NEO Instrucciones De Operación

Reset/Unsubscribe

The settings configured by you can be reset to the original factory
settings. The emergency numbers that have been programmed
are not removed, however. The registration details of the base
station are deleted. This means you will have to reregister the
EN
device with a base station before you can use it again.
Please complete the following steps to do this (the
distyNotruf
NEO must be registered with the base station):
distyNotruf
- Connect the
charging lead, the red LED will then shine and an acoustic
signal will ring out to confirm it is connected
- After 5 seconds at the latest, press and hold the alarm button
for 10 seconds – the green LED will start to shine
- Release the alarm button before the LED switches off again
(within 5 seconds)
- A tone can be heard and the red LED will start to shine
distyNotruf
- Remove the
charging lead
distyNotruf
- The
NEO
distyNotruf
To reset your
"ProgrammerApp" to do this.
34
with the voltage-supplied
NEO
from the voltage-supplied
NEO
switches itself off
to factory adjustment, use the
NEO
Operating instructions

Technical data

DECT/GAP, EN 300 444 (Frequency range and transmission
power: compliant with standards of EU/EFTA/AUS)
Compatible with all consumer DECT/GAP base stations and
all professional DECT systems
Compatible with FRITZ!Box and Speedport Neo
Button for distress calls and operation
LED Power indicator (in two colours)
Microphone and speaker
Standby time: > 120 hours | Speaking time: > 4 hours
Interface for programming
USB cable, Type A — USB, Type C
System requirements: Windows 7/8/10
Lithium-Ion battery, capacity: 450 mAh
Operating temperature: -10°C to +40°C
Storage temperature: -10°C to +60°C
Weight approx. 46 g (incl. wristband)
Plastic housing, 56 mm x 42 mm x 14 mm, Colour: anthrazite
Protection class: IP 65

Declaration of conformity

We, disty communications GmbH, declare that
conforms to the basic requirements and other relevant terms of
the 2014/53/EU guidelines (Radio Equipment Directive; RED).
The conformity is confirmed by the CE symbol.
The full declaration of conformity can be viewed on
our website: www.disty.de
Professional users will find additional information in
the service section of our website www.disty.de.
Operating instructions
EN
distyNotruf
NEO
35