Configuring The Device Without The "Programmerapp" (Pc) - Disty Notruf NEO Instrucciones De Operación

Configuring the device without the
"ProgrammerApp" (PC)
Subscription
Start the process on the base station of your normal DECT
telephone for registering a further mobile handset (see the
EN
operating instructions of your base station).
Connect the charging lead to the
plug the cable into a power supply. Now press and hold the
button until the green LED starts to shine (10 seconds). Release
the button within 5 seconds. The green LED will now start
flashing, which means the distyNotruf
base station that it can register with.
After successful registration, a loud acoustic signal will ring out.
This means the registration process has been completed.
"First incoming call" (only save the first emergency number)
– > voltage-supplied charging lead not plugged in
Ask the person (e. g. a family member, neighbour), who you
want to reach after pressing the button, to call you. Following
this the telephone number of the caller (CLIP) will be saved as
an emergency number after registration has been completed.
You will know that the emergency number has been saved
distyNotruf
successfully when the
as soon as the call has been accepted.
32
distyNotruf
and then
NEO
is looking for a
NEO
NEO ends the connection
Operating instructions
Programm all alarm numbers
To programm the alarm numbers by telephone, proceed as
follows (a new call is needed to save each individual alarm
number):
distyNotruf
- Call your from a normal telephone or
NEO
a mobile phone (not an internal call from another mobile
handset to the same base station)
distyNotruf
- Accept the call with your
avoid acoustic feedback, try to ensure the telephone and
distyNotruf
the are not in the same room when
NEO
programming the device.
- Enter the following numbers on the telephone, whereby
„xxxx" relates to the phone number you want to save.
When saving, any existing entries will be overwritten.
- For the 1st alarm number: **9 [wait 1-2 sec.] 2xxxxx #
For the 2nd alarm number: **9 [wait 1-2 sec.] 61xxxxx #
For the 3rd alarm number: **9 [wait 1-2 sec.] 62xxxxx #
For the 4th alarm number: **9 [wait 1-2 sec.] 63xxxxx #
For the 5th alarm number: **9 [wait 1-2 sec.] 64xxxxx #
- End the connection
Operating instructions
EN
. In order to
NEO
33