Stel HI-MIG 300K-P Manual Del Usuario página 46

ENGLISH
HI-MIG 300K-P 400V 3F
TECHNICAL DESCRIPTION
COD. 6902100050
letters At; with the V/SET encoder (ref.8 page 9) you can regulate the value from –40 to
+40%
To view the set value at any time, briefly press the SET button.
The ARC TRIM function allows you to vary the dynamic characteristics of the welding
arc: to weld with the presence of splashes, increase the ARC TRIM value; vice versa
for welds in which the wire tends to stick and burns with difficulty, decrease the ARC
TRIM value.
6) Regulating the BURN BACK time – Pressing the bb button (ref.9 page 9) selects the
wire BURN BACK time function. The right-hand display (ref.7 page 9) will start to blink
indicating the letters bb; with the V/SET encoder (ref.8 page 9) you can regulate the
value from 0.5 to 100 ms.
To view the set value at any time, briefly press the bb button.
The BURN BACK consists of a delay in switching off the welding arc with respect to the
stopping of the wire feeding device. When the value is set at 50 the wire feeding device
stops at the same time the arc goes out. For high welding currents it is advisable to set
the value at 50 (make a few tests).
Incorrect regulation of this parameter may lead to:
BURN BACK too low: at the end of welding the piece of wire protruding from the torch
is too long; it is therefore difficult to resume welding.
BURN BACK too high: at the end of welding the piece of wire protruding from the torch
is too short and in extreme cases the wire may stick to the current supply pipe.
7) Regulating the post-gas time - Pressing the PG button (ref.11 page 9) selects the
post-gas time. The right-hand display (ref.7 page 9) will start to blink, indicating the
letters PG; with the V/SET encoder (ref.8 page 9) you can regulate the value from 0.1
to 12.5 seconds.
To view the set value at any time, briefly press the PG button.
8) Gas PURGE function – Pressing the PURGE button (ref.12 page 9) directly enables
the gas output electrovalve to make the gas come out of the torch.
9) INCH wire advance function – Pressing the INCH button (ref.13 page 9) enables the
motor of the wire feeding device; the wire is immediately made to advance slowly for
two seconds, after which the speed increases. The purpose of this function is to make
the wire run inside the torch in the welding preparation phase.
MIG 2 TIMES welding procedure: manual regulation
Starting welding:
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
46