Connection; Receiving The Material; Complaints - Stel HI-MIG 300K-P Manual Del Usuario

ENGLISH

3.0 - CONNECTION

3.1 - RECEIVING THE MATERIAL

The package contains:
N°1 current generator for welding
-N°1 setting-up Kit
-N°1 Kit of rollers
N° 1 manual
Check that all the material listed above is included in the package. Notify your
distributor if anything is missing. Ensure that the generator has not been damaged
during transport. If there is any visible damage, see the COMPLAINTS section (Par.
3.2) for instructions. Read this instructions manual carefully before working with the
generator.

3.2 - COMPLAINTS

Complaints for damage during transport: If your equipment is damaged during
transit you must present a claim to the carrier.
Complaints for faulty goods: All the equipment shipped by STEL is subjected
to strict quality control. However, if your equipment does not work properly, consult
the TROUBLESHOOTING section of this manual. If the fault persists, consult your
authorised dealer.
3.3 - PRIMARY CONNECTION
INSTALLATION
WARNING: This Class A equipment is not intended for use in residential
locations where the electrical power is provided by the public low-voltage supply
system. There may be potential difficulties in ensuring electromagnetic compatibility
in those locations, due to conducted as well as radiated disturbances.
This equipment does not comply with IEC 61000-3-12. If it is connected to a
public low voltage system, it is the responsibility of the installer or user of the
equipment to ensure, by consultation with the distribution network operator if
necessary, that the equipment may be connected.
The good operation of the generator is ensured by correct installation; you must
there fore proceed as follows:
- Position the machine in such a way that there is no obstacle to the air circulation
ensured by the internal fan (the internal components require suitable cooling) (see
chap. 6.1).
- Ensure that the fan does not send deposits or dust into the machine.
- Avoid impacts, rubbing, and - absolutely - exposure to dripping water, excessive
heat sources, or any abnormal situations.
MAINS VOLTAGE
The generator works at mains voltages differing by 20% from the rated mains value
of 400V (Minimum voltage 320V, maximum voltage 480V).
STEL s.r.l. – Via del Progresso n° 59 – 36020
Loc. Castegnero (VICENZA) - ITALY
TEL. +39 444 639525 (central.) – +39 444 639682 (comm.)
FAX +39 444 639641 – E-mail: stel @ stelgroup.it
http: www.stelgroup.it
HI-MIG 300K-P 400V 3F
COD. 6902100050
Cod. 603030000L HI-MIG 300K-P
Cod. 606180000L
Cod. 604610000L
TECHNICAL DESCRIPTION
Cod. 6902100050
37