Installation - Glacier bay N2441E Guía De Uso Y Cuidado

Installation

1
Removing the old toilet
□
Turn off the water supply and flush the tank completely.
Towel or sponge remaining water from the tank and bowl.
□
Disconnect and remove the old water supply line.
□
Remove the bowl from the floor by removing the bolt caps
and the floor bolt nuts.
□
Remove the floor bolts from the toilet flange and clean old
wax, putty, and sealant from the base area.
□
Temporarily plug the floor flange with a towel or cover to
block sewer gases from escaping.
NOTE: The mounting surface must be clean and level
before the new toilet is installed.
2
Installing the floor bolts
□
Insert the floor bolts (AA) into the slots on the toilet flange
(1) with the bolt heads down and threaded ends facing up.
The heads of the floor bolts (AA) should be perpendicular to
the slot opening in the toilet flange.
□
Ensure the floor bolts (AA) are parallel to the wall. When
set, hand-tighten the hex nuts (BB) onto the floor bolts (AA)
to secure.
5
Please contact 1-855-434-5224 for further assistance.
HOMEDEPOT.COM