Care And Cleaning - Glacier bay N2441E Guía De Uso Y Cuidado

Installation (continued)
9
Installing the seat with lid
□
Turn the toilet seat with lid (C) upside-down.
□
Insert the lock-bolt (NN) in the bolt trough (1), then adjust
the lock-bolt (NN) to make the hole distance match with the
toilet.
□
Turn the toilet seat with lid (C) over so that the lock-bolts
(NN) protrude downward.
□
Insert the lock-bolts (NN) into the holes on the toilet (B) and
adjust the toilet seat and lid (C) to find the best assembly
position.
□
Place the washer (OO) and the lock-nut (PP) onto the lock
bolt (NN) from underneath the toilet (B) and tighten the
lock-nut (PP) firmly to secure the seat and lid (C) in place
on the toilet (B).

Care and Cleaning

Your new toilet is made of stain-, acid- and abrasion-resistant vitreous china. Clean the outside surface with mild soap, warm water and
a soft cloth. On stubborn stains use a powdered detergent and damp sponge or nylon scouring pad. Never use abrasive scouring
powders, cleansers or pads because they will scratch, damage and dull the surface. The manufacturer shall not be responsible or liable
for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hypochlorite). When cleaning your toilet seat,
wash it with mild soapy water. Rinse the seat thoroughly with clean water and dry with a soft cloth. Avoid detergents, disinfectants or
cleaning products in aerosol cans. NEVER use abrasive scouring powders on your seat. Some bathroom chemicals and cosmetics may
cause damage to the seat's finish, so test your cleaning solution on an inconspicuous area before applying to the entire surface.
WARNING: DO NOT USE IN-TANK CLEANERS. Products containing chlorine (calcium hypochlorite) can seriously damage tank fittings
potentially causing leaks, excessive water use and property damage.
10
Installing the side plate
1. Take out the bolt covers with the buckle of the bolt cover
facing up.
2. Make sure both ribs on the back of the bolt cover align with
the ceramic cut out on the toilet
3. Put the top of buckle into the ceramic cut out then slide in
the bolt cover from bottom to top – making sure everything
is aligned
4. Install the other bolt cover the same way.
5. To remove the bolt cover, pry off the bottom of the bolt
cover from the toilet by hand. Do not pry from the top.
6. Lift the side plate from the bottom and remove.
7. Disassemble the other side plate in the same manner.
8