Ryobi RCS5133CB Traducción De Las Instrucciones Originales página 6

Fully press and release the primer bulb
at least 10 times.
Pull the choke lever all the way out the
START position.
of the engine is heard (no more than
Set the choke lever to the RUN
position.
Pull starter grip until the engine starts.
Depress the trigger release.
Fuel and oil
Bar and chain lubricant
Rotate to adjust chain tension
+ = Tighten the chain
- = Loosen the chain
Moving direction of the chain
H = High speed adjustment needle
L = Low speed adjustment needle
T = Idle adjustment screw
Set the ignition switch to the "STOP"
position.
SERVICE
Servicing requires extreme care and knowledge and should
service we suggest you return the product to your nearest
authorised service centre for repair. When servicing, use
only identical replacement parts.
4
WARNING
To avoid serious personal injury, do not attempt
to use this product until you read thoroughly and
understand completely the operator's manual. If you
do not understand the warnings and instructions in the
operator's manual, do not use this product. Call Ryobi
customer service for assistance.
WARNING
The operation of any power tool can result in foreign
objects being thrown into your eyes, which can result
in severe eye damage. Before beginning power tool
operation, always wear safety goggles or safety glasses
with side shields and, when needed, a full face shield.
We recommend Wide Vision Safety Mask for use over
eyeglasses or standard safety glasses with side shields.
Always use eye protection which is marked to comply
with EN 166.
WARNING
Long term inhalation of the engine's exhaust fumes,
chain oil mist and sawdust can result in serious personal
injury.
Save these instructions and pass them on if the saw is to be
used by another person.
DESCRIPTION
Go to page 139
1. Front hand guard/Chain brake
2. Front handle
3. Engine cover
4. Primer bulb
5. Choke lever
6. Chain
7. Starter grip
8. Guide bar
9. Trigger release
10. Chain lubricant cap
11. Silencer
12. Carburettor adjustment
13. Rear handle
14. Throttle trigger
15. Fuel mix cap
16. On/off switch
17. Starter/Fan housing
18. Spiked bumper
19. Chain catcher
OPERATION
For your safety, study this entire manual before operating
the saw. Pay particular attention to the precautions and
instructions listed in the operator's manual.
English