Installation And Lubrication; Parts And Maintenance - Ingersoll Rand 7802SA Especificaciones Del Producto

Product Safety Information
Intended Use:
It is designed to cut steel, aluminum, tin and other materials up to 20 gauge (1 mm).
For additional information refer to Air Shear Product Safety Information Manual Form
04580494.
Manuals can be downloaded from www.ingersollrandproducts.com
Product Specifi cations
Handle
Models
Type
7802SA Pistol
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air fi lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-off , to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 16573818 and table on page 2. Maintenance frequency is shown in a circular
arrow and defi ned as h=hours, d=days, and m=months of actual use. Items identifi ed as:
1. Air fi lter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Offi ce or Distributor.
04580502_ed4
Max.
Free
Material
Speed
Thickness
Strokes/ Gauge/
min. Inch/mm
4200 20/.04/1.0
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
P
83 94
6. Thread size
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fi tting
EN
2
Vibration (m/s )
(ISO28927)
) Level *K
W
3.0 1.0
EN-1