Schlage BE365 Manual Del Usuario página 2

BE365 Door Preparation Instructions For Door With No Holes
Tools Needed
1
Measure Door Width
If the door is thinner than 1³⁄₈" or thicker than 1³⁄₄", then the
lock will not fit properly on the door.
1³⁄₈" - 1³⁄₄"
2
Mark Lock Centerline on Door Face and Door Edge
Door Edge
Tape Measure
Pencil
Drill Bits Needed:
¹⁄₈", ⁷⁄₈", 1"
2¹⁄₈" Hole Saw
Chisel
Door Face
38" from finished floor
3
Mark and Drill Hole in Door Face with 2¹⁄₈" Hole Saw
a
2³⁄₈" or 2³⁄₄"
c
2¹⁄₈" Hole Saw
4
Mark and Drill Hole in Door Edge
a
¹⁄₂" Door
Width
c
1" Drill Bit
b
d
b
d