Schlage BE365 Manual Del Usuario página 3

5
If Necessary, Mortise for Latch
a. Insert latch into door edge hole.
b. Use pencil to trace latch and mark holes.
c. Remove latch and drill two ¹⁄₈" pilot holes.
d. Use chisel to create latch mortise.
a
c
¹⁄₈" Drill Bit
6
Measure and Mark Door Jamb for Strike
a. Measure 38" from finished floor and mark on door jamb.
b. Mark center for strike hole exactly opposite latch hole.
Door Jamb
38" from Floor
a
FOR
OR
b
d
Latch Hole
b
38" From
Floor
7
Mark and Drill Holes for Strike
a. Drill two (2) 1" holes, 1¹⁄₄" deep, as shown. Chisel out excess
material.
b. Line up strike box and strike with hole in door jamb.
c. Use pencil to trace strike and mark holes.
d. Drill five (5) ¹⁄₈" pilot holes and use chisel to create strike
mortise.
a
b
d
¹⁄₈" Drill Bit
¹⁄₄"
¹⁄₄"
1" Drill Bit
c
© Allegion 2014
Printed in U.S.A.
BE365 DP no holes Rev. 11/14-online