Inserting Accessories; Important Information On Installation; Built-In Appliances - Blaupunkt 5C90S8990 Instrucciones De Uso

Inserting accessories

The cooking chamber has five guide rails. The guide rails are counted from bottom to top.
The accessories can be pulled out about halfway without tilting.

IMPORTANT INFORMATION ON INSTALLATION

• This appliance is NOT intended for use in a commercial environment.
• Please refer to the supplied installation instructions and note that this equipment should only be
installed by a qualified technician.
• This appliance is equipped with a plug and may only be connected to a properly installed
earthed socket.
• If a new socket is required, only a qualified electrician may install the appliance and connect
the cables.
• If the plug is no longer accessible after installation, a pole separator with a contact gap of at
least 3 mm must be provided at the installation site.
• Adapters, socket strips and extension cables must not be used. Overloading can lead to fire.
• If the appliance has no supply line and no plug, the connection device must have an all-pole
contact separation for complete disconnection. In addition, the appliance must be installed in
the fixed wiring according to the wiring rules.

BUILT-IN APPLIANCES

• The appliance is only intended for installation in a kitchen.
• The appliance is not intended for use as a table appliance or inside a cabinet.
• The built-in cabinet may not have a rear panel behind the unit.
• A distance of at least 35 mm must be maintained between the wall and the rear wall or the floor
of the appliance located above it.
• The built-in cabinet must have a ventilation opening of 200 cm
the base plate must be cut back or a ventilation grille must be fitted.
• The ventilation slots and air intake openings must not be covered.
• Safe operation of this appliance can only be guaranteed if it has been installed in accordance
with these installation instructions.
• The installer is liable for all damage caused by improper installation.
• The cabinets in which the appliance is installed must be heat-resistant.
Accessible parts become
hot during operation.
2
7
at the front. For this purpose,