Connecting The Drain Hose - Haier QFT15 Serie Manual Del Propietário

CONNECTING THE DRAIN HOSE

DRAINING WATER WITHOUT USING
THE WATER TANK
You can use the dryer without using the water tank by
following the procedures below.
CONNECTING THE DRAIN HOSE
The dryer can pump the condensed water outside of the
DRYER directly with drain hose provide.
The procedures to connect the drain hose are as follows.
1. Disconnect the drain hose A.
2. Connect the drain hose A to
the other hole.
3. Connect accessory hose B
(long drain hose) adjacent to
hose A.
• When connecting hose B, take care that the height of
the hose does not exceed 47" (120 cm).
• After connecting the drain hose, you can now directly
drain the condensed water to a standpipe or washstand.
18
INSTALLATION INSTRUCTIONS
Back
View
A
A
B
CONNECTING THE DRAIN HOSE
(CONT.)
4. Over the edge of a wash basin: The drain hose must
be placed lower than 47" (120 cm) and higher than 30"
(76 cm). To keep the drain hose spout bent, use the
supplied plastic hose guide. Secure the guide to the
wall with a hook or to the tap with a piece of string to
prevent the drain hose from moving.
5. Assemble the drain hose and the hose guide and fix
them with the cable-tie.
Hose Guide
Drain Hose
Cable Ties
Do not push the drain hose in the standpipe any further
than 4" (10 cm). Pushing the drain hose further in the
standpipe can cause leaking.
47"
(120 cm)
Max.
49-3000193