Layout - Storage; I- Adding Or Changing The Position Of A Sliding Shelf - PURE EuroCave Modo De Empleo

I. Adding or changing the position of a sliding shelf
If the sliding shelf is already in place in your cabinet:
•
Completely unload the sliding shelf.
•
Then remove the sliding shelf by sliding it towards you whilst lifting the front section.
•
Remove the slide guides from the walls, marking off the right guide and the left guide.
•
Refit the slide guides (see diagram below).
A. Putting in place the back section of the guide
Wall
Guide
Wall
Guide
C. Then place the sliding shelf
Sliding shelf
ACMS
Guide
ACMS 2
The latch of the soft-close device may not be locked (left runner).
It is essential to lock it before positioning the sliding shelf on the runners.
Ensure that the latch is correctly positioned at the front.
If it is not, pull it towards the front to lock it.
a.
12
GB
5 - l – s
Ayout toRAge
B. Putting in place the front section of the guide
Guide
Wall
Guide
Wall
b.
5 - l – s
Ayout toRAge
a.
b.
TAC !
d.
Slide the shelf along until the back fasteners of the shelf lock into
the slots provided in the runners.
f.
2
1
Note: In order to prevent the shelf from tipping, ensure that the studs on each side of the shelf are pushed all the way
into the holes before pushing the shelf back in.
1
2
c.
1
2
Place your shelf on the left and right runners and start by locking
the back section of the shelf.
e.
Then place the front studs of the shelf into the slots provided in
the front section of the runners. It is necessary to jiggle the shelf in
order to make the studs slot into the holes. Tip: Start by inserting
the left stud. The right stud will then easily slot into the oblong hole.
g.
2
1
13
GB