Ii- Adding Or Changing The Position Of A Storage Shelf Axuh2 - PURE EuroCave Modo De Empleo

II. Adding or changing the position of a storage shelf AXUH2
a.
b.
Note: to install a storage shelf the back section of which rests on the ledge, located at the back of the cabinet, fit 2 rack support pins at
the front to support the front section of the shelf (pins supplied in the accessories bag).
The same applies if you place a storage shelf just above the stiffener, position two rack support pins at the back of the cabinet (for large
models only).
III. Assembly and use of shelf labels
The shelf labels in epoxy coated steel allow you to identify your bottles and locate
them easily. White marker pen supplied in the accessories bag (erasable).
b.
14
GB
5 - l – s
Ayout toRAge
1
c. d.
1
back
wall 2
(supplied with ACMS2 and AXUH2 shelves)
c.
6 - c
1. Connection and starting up
Wait 48 hours before plugging in your wine cabinet.
To switch it on, press and hold down button
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker).
Do not plug several cabinet into a multi-socket.
II-A. Description (1-temperature model V-Pure-S, V-Pure-M, V-Pure-L)
A B C
2
P
A
Lighting mode
B
Open door alarm
C
Temperature zone
D
Sensor fault alarm
E
Temperature alarm
F
Charcoal filter alarm
G
Confirmation and setting access key
H
Setting and selection keys
II-B. Temperature setting
Press and hold down the
1
Press and hold down the
The display will start to flash
2
Press the or
3
Press the button to confirm
ommissioning youR Wine cABinet
for 5 seconds.
Check your type of wine cabinet
Press the
D E F G H
O N M L K
I
Lighting mode confirmation and access key
J
Charcoal filter meter access key
K
Standby key
L
Humidity level alarm
M
Relative humidity level display
N
Heater in-use light
O
Compressor in-use light
P
Temperature display
The value shown on the display is the actual temperature inside
the cabinet. It is therefore necessary to wait before your new
setting takes effect.
5 sec.
•
The default setting is 12 °C / 54°F (ideal maturing temperature).
key for 5 seconds to start up.
However, you can set the temperature from 5 to 20 °C / 41 to 68°F.
•
Recommended temperature setting range for maturing wine: 10 -14 °C /
key for approximately 5 seconds.
50 - 57°F.
N.B.: to function correctly, your cabinet must be placed in a room with a
temperature of 0 - 35 °C / 32 - 95°F.
keys to set the desired temperature
and keys at the same time.
I
The tactile keys are very sensitive.
There is no need to apply force, only a
light touch is required to register the
command.
Remember to remove your finger from
the panel between each press.
J
15
GB