Fein MultiMaster FMM 250 Instrucciones De Uso página 12

EN
Changing the tool.
The application tool can be fastened offset at convenient working positions at 45°
steps (or at 30° steps for the triangle-shaped sanding pad).
M M FMM 250 Q (Figure 3).
ULTI ASTER
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chan-
CAUTION
ging application tools,
always wear protective gloves. Danger of
injury from the sharp edges of the applica-
tion tools. Application tools can become
very hot while working. Danger of burns!
➤
Loosen the quick-clamping lever
and swivel it to the stop.
➤
Pull out the fastening element.
➤
Clean the tool holder, the applica-
tion tool and the fastening element.
➤
Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
➤
Insert the fastening element to the
stop into the tool holder.
➤
Swivel the quick-clamping lever back
until it engages.
Protect your hand and fin-
CAUTION
gers from being bruised/
crushed from the snapping back quick-clam-
ping lever. The quick-clamping lever pivots
back powerfully due to the spring force.
12
M M
ULTI
All manuals and user guides at all-guides.com
Fig. 3
Tool holder
Quick-clamping lever
FMM 250 / M
ASTER ULTI
Fastening element
M FMM 250 Q
ASTER
180°