Descargar Imprimir esta página

Fein MultiMaster FMM 250 Instrucciones De Uso página 13

Ocultar thumbs Ver también para MultiMaster FMM 250:

Publicidad

Idiomas disponibles

Idiomas disponibles

M
M
FMM 250 / M
ULTI
ASTER
M
M
FMM 250 (Figure 4).
ULTI
ASTER
Before mounting or replacing
WARNING
application tools or accesso-
ries, pull the power plug. This preventive
safety measure rules out the danger of inju-
ries through accidental starting of the
power tool.
For all work or when chan-
CAUTION
ging application tools,
always wear protective gloves. Danger of
injury from the sharp edges of the applica-
tion tools. Application tools can become
very hot while working. Danger of burns!
Unscrew the clamping screw.
Clean the tool holder, the applica-
tion tool and the clamping screw.
Place the application tool exactly
onto the star-shaped tool holder. Pay
attention that the application tool has a
flush fit.
Tighten the clamping screw using
the supplied Allen key.
Attaching/replacing the sanding sheet (Figure 5).
Align the sanding sheet and press it
onto the sanding plate by hand.
Firmly press the power tool with the
sanding sheet against a flat surface and
briefly switch the power tool on. This
provides for good adhesion and pre-
vents premature wear.
The sanding sheet can be pulled off again
and then remounted offset by 120° when
only one tip of the sanding sheet is worn.
M
FMM 250 Q
ULTI
ASTER
All manuals and user guides at all-guides.com
Fig. 4
Clamping screw
Tool holder
Allen key
Fig. 5
Sanding sheet
Sanding pad
EN
13

Publicidad

loading

Este manual también es adecuado para:

Multimaster fmm 250 q7 229 367 229 373702338381