Name/Function Of Each Part - HoMedics BPM-010 Manual Del Usuario

Arm Cuff
Stethoscope
Metal D-Ring
Ear Tips
Stethoscope
Microphone
ASSEMBLY INSTRUCTIONS
1. Insert tubes into stethoscope.
2. Insert tube into stethoscope microphone.
1
Pressure Gauge
Inflation Bulb
Air Flow Valve
2
140 160 180
120 200
100 220
80 240
60 260
SPHYGMOMANOMETER CERTIFIED
40 280
20 300
mmHg
7

NAME/FUNCTION OF EACH PART

USING THE ARM CUFF
Very Important: Proper cuff size is critical to
accurate measurement.
This monitor is equipped with a Standard Size
arm cuff that fits arms with circumferences
of 8.25"–14.2" (21 cm – 36 cm). Measure the
circumference of your upper arm to ensure
that it falls within this range. If an alternative
cuff size is needed, you may contact
HoMedics Consumer Relations for more
information.
1. If the cuff is not assembled, pass the end of
the cuff furthest away from the tubing through
the metal D-ring in order to form a loop. The
smooth side without the felt material should
be on the inside of the cuff l oop.
End of cuff
D-ring
2. Open the arm cuff so that your arm may be
placed through it.
3. Remove tight fitting clothing from around
your upper left arm.
Felt Material on
the outside of
cuff
8