Clock And Timers; Setting Alarm - THOMSON DS120DABCD Modo De Empleo

Clock and Timers

Setting the Clock
After the unit is plugged into a mains supply or following a mains power failure, the display will show
"0:00" on the LCD display. The unit should be in standby mode to set the current clock.
1. Press TIME button, and the digits for the display will blink.
2. Long press the
setting.
3. The minute digits on the display will blink.
4. Press the /
setting.

Setting Alarm

This unit may be used as an alarm clock. The Bluetooth device, USB device or FM radio is activated
to play at a preset time.
1. Press to switch the unit to standby mode.
2. Make sure that you have set the clock correctly.
3. Press ALARM button in shutdown state; the display will flash ON to select the alarm setting
function, and the display will blink.
4. Press ENTER to confirm, and the time display will blink.
repeatedly to set hour. Press ENTER to confirm.
5. Press /
6. Press / to set minute.
7. Press ENTER to confirm, and then press
to confirm.
8. The volume may be gradually adjusted from 0 to 20.
9. Press ALARM button in shutdown state; the display will flash ON to select alarm setting mode,
and the display will blink.
10. Press / to select OFF to cancel alarm.
Snooze
1. Press to make the alarm ring again in 9 minutes.
2. Press to make the alarm ring again in 9 minutes, once the alarm rings again-.
3. Press to reset snooze function.
Sleep Timer
1. Press the SLEEP button, and the display will blink. Press the button until the display shows the
number of minute you want to set. You can set 90/60/45/30/15 minutes.
2. The display blinks three times to confirm, and then returns to the previous interface. If you want to
cancel the sleep mode, press OFF; after blinking three times, the sleep mode will cancel.
Playing Media Files
Disc
Play a disc
1. Press SOURCE repeatedly to select DISC source.
2. Insert a disc with the printed side facing to the front.
3. Play should start automatically; if not, press
4. Press the VOL+/VOL – to adjust the volume.
Pause / resume play
• During play, press
• During play, long press
Skip to a track
For CD:
1. Press /
button repeatedly until correct hour is set. Press ENTER to confirm the hour
/
button repeatedly until correct minute is set. Press ENTER to confirm the minute
to pause/resume play
/ button to fast forward/fast rewind
to select another track.
to select CD/DAB/FM/USB status. Press ENTER
/
.
- EN 5 -